It also required me to build another new fuselage for test fitting the final parts. It took the better part of a day to redo all of the skins and the inner supports. With seating for four people, aft-section living accommodations including bunks and food replicators, and a two-person transporter, the runabout was capable of more. This was important for the final fit of the warp engines, and for the clamping straps. A generic terminology for the small, warp -capable Federation starships used for short-range missions actually of the Danube class, first put into service in 2367. It was a bit over an 1/8th of an inch too deep in the lower sections, so I had to put everything on a diet, and whittle it down. Up to this point, all of the larger assemblies had attached to the upper parts of the hull, but checking the fuselage against the original, and against the AMT plastic kit, showed that my version was "pot-bellied". Modeling the clamping strap and the warp engines revealed an issue that required reworking every section of the model I'd already designed. So much so that the collected test builds of all these different sections filled a large bankers box by the time I finished the project. In the end, my own version of the bussard uses Ninjatoes' squared edges, but with corrections to the shape and a few changes to the assembly of the forward ends of the warp engines, which make the hard edges stand out a bit less.Ī few of the "unsuccessful" test builds.Īs the redesign progressed, I was constantly building and rebuilding the different sections of the model, as each new change had to be tested for the best fit. Even if I worked in CAD or a 3D modeling program to design it, the actual parts would be horrendous to build. The problem with rounding the bussard is that the shape of the prototype is a tight, flattened sphere that fades into a rectangle where it meets the hull plating. I played with the idea quite a bit, and looked at Paragon's repaint of the runabout, where he had eased the corner with a multi-pieced bussard, but I had a really hard time building his version. During the design and test building, I was asked by another modeler if I had rounded off the bussard collectors on the warp engines, as Ninjatoes' original design had a sharp corner at the top and bottom edges of the bussards. Once that was done, I moved on to the warp engines.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |